HP Thin Client PC t1010 T1000/T1010 Series Windows-based Terminal Administrato - Page 274
Modem AT Commands
View all HP Thin Client PC t1010 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 274 highlights
49 Modem AT Commands The tables of this section list typical modem AT command sets. Table 49-1 AT Commands with No Lead-in Character Command Description B, B0 ITU-T (CCITT) V.22 mode when at 1200 bps; V.21 at 300 bps E1 Enable character echo to terminal in command mode H, H0 Go on-hook (hang up) N1 Connection speed set to highest possible DCE rate, Automode Q, Q0 Modem returns result codes (Quiet disabled) T Tone dialing V1 Full-word result codes (Verbose enabled) W2 Negotiation progress codes disabled. Result code is DCE rate X4 Modem recognizes dialtone and busy, CONNECT nnnn result code enabled Y, Y0 Disable long-space disconnect Z, Z0 Reset modem and recall User Profile 0
49
Modem AT Commands
The tables of this section list typical modem AT command sets.
Table 49-1
AT Commands with No Lead-in Character
Command
Description
B, B0
ITU-T (CCITT) V.22 mode when at 1200 bps; V.21 at
300 bps
E1
Enable character echo to terminal in command mode
H, H0
Go on-hook (hang up)
N1
Connection speed set to highest possible DCE rate,
Automode
Q, Q0
Modem returns result codes (Quiet disabled)
T
Tone dialing
V1
Full-word result codes (Verbose enabled)
W2
Negotiation progress codes disabled. Result code is
DCE rate
X4
Modem recognizes dialtone and busy, CONNECT
nnnn result code enabled
Y, Y0
Disable long-space disconnect
Z, Z0
Reset modem and recall User Profile 0