HP Visualize J7000 hp Visualize J5000, J7000 workstations service handbook (a4 - Page 106
Removing the Filler Panels from the Bracket
View all HP Visualize J7000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 106 highlights
Field Replaceable Units (FRUs) FRU Removal and Replacement 3. If you are installing a new DDS-3 tape drive into the empty DDS-3 tape/floppy disk drive bay: a. Remove the two T-15 Torx screws securing the DDS-3 tape/floppy disk drive bracket to the front panel of the workstation. b. Slide the DDS-3 tape/floppy disk drive bracket out of the chassis guide rails. c. Remove the filler panels from the DDS-3 tape/floppy disk drive bracket as shown in Figure 4-13. Figure 4-13. Removing the Filler Panels from the Bracket 4. Insert the DDS-3 tape drive into the bracket and secure the drive in the bracket using four of the six T-10 Torx screws (two on each side). Figure 4-14. DDS-3 Tape Drive Installed in the Bracket 5. Connect the power and ribbon cables in the drive bay to the rear of the DDS-3 tape drive. 6. Push the DDS-3 tape/floppy disk drive bracket assembly into the drive bay, taking care not to pinch the cables. Seat the bracket assembly flush against the front panel. 102 Chapter 4