HP Visualize b1000 hp workstation b1000 and c3000 - pa8700 upgrade instruction - Page 9

Upgrading Your System

Get HP Visualize b1000 - Workstation PDF manuals and user guides View all HP Visualize b1000 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 9 highlights

2 Upgrading Your System Upgrading Your System Bezel Labels This chapter describes how to upgrade the labels on your workstation's bezel and how to remove and replace the System Board for the B1000/C3000 workstation. Bezel Labels If you are upgrading your system board to change your workstation to a C3700, you will receive an upgrade kit that includes the appropriate labels for your workstations bezel. This section explains how to remove the old bezel label and replace them with two new ones. Removing the Current Bezel Label There is currently only one label on your workstation's bezel. This label is located at the top of the bezel. To remove this bezel label, follow these steps: 1. Follow the procedure found in your Owner's Guide for removing the workstation's bezel. 2. Rotate the bezel over so that its back side is facing you, and with needle-nose pliers squeeze inward on the label's rivets and push toward the front of the bezel. See Figure 2-1. Figure 2-1 Pushing Inward on the Bezel Label's Rivets Bezel's Top Label Rivets Chapter 2 9

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
Chapter 2
Upgrading Your System
Bezel Labels
9
2
Upgrading Your System
This chapter describes how to upgrade the labels on your workstation’s bezel and how to remove
and replace the System Board for the B1000/C3000 workstation.
Bezel Labels
If you are upgrading your system board to change your workstation to a C3700, you will receive an upgrade
kit that includes the appropriate labels for your workstations bezel. This section explains how to remove the
old bezel label and replace them with two new ones.
Removing the Current Bezel Label
There is currently only one label on your workstation’s bezel. This label is located at the top of the bezel.
To remove this bezel label, follow these steps:
1.
Follow the procedure found in your
Owner’s Guide
for removing the workstation’s bezel.
2. Rotate the bezel over so that its back side is facing you, and with needle-nose pliers squeeze inward on the
label’s rivets and push toward the front of the bezel. See Figure 2-1.
Figure 2-1
Pushing Inward on the Bezel Label’s Rivets
Label Rivets
Bezel’s Top