HP Visualize c160L hp workstations - hp-ux 10.20 graphics administration guide - Page 85
Specifying hp-HIL Input Device Use by Device File Name
View all HP Visualize c160L manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 85 highlights
If you had a more complicated configuration, such as two graphics tablets, two keyboards, and a barcode reader, your X*devices file could look like this: • first tablet pointer The pointer • second tablet other Merged with the pointer • first keyboard other Merged with the keyboard • second keyboard keyboard The keyboard • first barcode other Merged with the keyboard In this example, the first tablet acts as the pointer, the second keyboard acts as the keyboard, input from the second tablet is treated as if it came from the X pointer, and input from the first keyboard and the barcode reader is treated as if it came from the X keyboard Note: The barcode reader is in ASCII mode in this example. If the barcode reader were in keyboard mode, the last line of the example would read as follows: third keyboard other More examples can be found in the X0devices file in /usr/newconfig/etc/X11 Specifying hp-HIL Input Device Use by Device File Name The device can be specified using the name of the device to which it is attached. This can be done by adding an entry to the X*devices file with the form: // # where: / Specifies the name of the device file associated with the input device. is "keyboard", "pointer", or "other". # Describes the device. Comments are optional, but if present, must be preceded by a "#". This syntax should be used if more than one X server will be running on the computer, or if non-X programs will be accessing the input devices. It refers to a specific position on the hp-HIL. Page 85 Graphics Administration Guide for HP-UX 10.20