HP W17q User Guide 1506, 1706 and 1906 LCD Monitors - Page 20

Removing the Monitor Base

Get HP W17q - Compaq - 17inch LCD Monitor PDF manuals and user guides
UPC - 883585001200
View all HP W17q manuals
Add to My Manuals
Save this manual to your list of manuals

Page 20 highlights

Setting Up the Monitor Removing the Monitor Base You can remove the monitor base to mount the monitor on a wall, a swing arm, or other mounting fixture. Read the Caution and Warning statements below before beginning the procedure. Ä CAUTION: Before beginning to disassemble the monitor, be sure the monitor is turned off and the power and signal cables are both disconnected. If your monitor has a connected audio cable, disconnect it. Ä CAUTION: Do not remove the base from the monitor while the monitor is in the upright position. Lay the front bezel down on a soft area to prevent it from getting scratched, defaced, or broken. 1. Disconnect and remove the signal and power cables from the back of the monitor. 2. Remove the stand cap 1 from the top of the pedestal pillar. 3-6 User Guide

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
3–6
User Guide
Setting Up the Monitor
Removing the Monitor Base
You can remove the monitor base to mount the monitor on a wall,
a swing arm, or other mounting fixture. Read the Caution and
Warning statements below before beginning the procedure.
Ä
CAUTION:
Before beginning to disassemble the monitor, be sure
the monitor is turned off and the power and signal cables are both
disconnected. If your monitor has a connected audio cable,
disconnect it.
Ä
CAUTION:
Do not remove the base from the monitor while the
monitor is in the upright position. Lay the front bezel down on a soft
area to prevent it from getting scratched, defaced, or broken.
1. Disconnect and remove the signal and power cables from the
back of the monitor.
2. Remove the stand cap
1
from the top of the pedestal pillar.