HP Workstation x4000 hp workstation x4000 - accessory installation guide - Page 35

Installing a Graphics Card

Get HP Workstation x4000 PDF manuals and user guides View all HP Workstation x4000 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 35 highlights

Figure 2-12 Installing Accessories Graphics Card Removing the Graphics Card Retaining Screw NOTE Installing a Graphics Card To install a graphics card: 1. If you are replacing an existing card, remove the current card (see page 32). 2. Unscrew and remove the rear slot panel that corresponds AGP PRO 4X connector. The screw you removed is used to retain the graphics card. If you are installing a full-length graphics card, you must remove the graphics board retaining screw near the front of the chassis as shown in Figure 2-13. Chapter 2 33

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
Installing Accessories
Graphics Card
Chapter 2
33
Figure 2-12
Removing the Graphics Card Retaining Screw
Installing a Graphics Card
To install a graphics card:
1.
If you are replacing an existing card, remove the current card (see
page 32).
2.
Unscrew and remove the rear slot panel that corresponds AGP PRO
4X connector. The screw you removed is used to retain the graphics
card.
NOTE
If you are installing a full-length graphics card, you must remove the
graphics board retaining screw near the front of the chassis as shown
in Figure 2-13.