HP t5500 Safety & Regulatory Information: Thin Clients - Page 13

2 Power Supply and Power Cord Set Requirements Power Supply Requirements For safety reasons, use only the AC adapter provided with the unit or an authorized replacement adapter from Hewlett-Packard. Power Cord Set Requirements The power cord set (flexible cord or wall plug) received with this product meets the requirements for use in the country where you purchased the equipment. If you need to obtain a power cord for a different country, you should purchase a power cord that is approved for use in that country. The power cord must be rated for the product and for the voltage and current marked on the product's electrical ratings label. The voltage and current rating of the cord should be greater than the voltage and current rating marked on the product. In addition, the diameter of the wire must be a minimum of 0.75 mm2 or 18AWG, and the length of the cord must be between 1.8 m (6 feet) and 3.6 m (12 feet). If you have questions about the type of power cord to use, contact the HP authorized service provider. A power cord should be routed so that it is not likely to be walked on or pinched by items placed upon it or against it. Particular attention should be paid to the plug, electrical outlet, and the point where the cord exits from the product. Å WARNING: Do not operate this product with a damaged power cord set. If the power cord set is damaged in any manner, replace it immediately. Safety & Regulatory Information www.hp.com 2-1