Hitachi 32PD5000 Owners Guide - Page 58

1.

ϖʔδ Caution Make sure the monitor power is switched off (with the standby/ receive lamp switched off or red) before you connect or disconnect the speaker cables. Attach the speaker systems to the monitor. 1 Attach the speaker brackets to the speaker systems. Attach the screws in a position that allows you to read the speaker holder orientation markers (R), (L). In the case of (R) Speaker holder screw X 2 R Speaker screw X 2 holder L (R) (L) Cushion Notice Use of cushions In some cases, there can be a gap between the main unit and the speaker. You can attach the cushions provided to the side of the speaker system, if desired, to eliminate the gap. Cushion Attach the cushions to the sides of the speakers facing the main unit. Align the cushions to the front of the back case and affix them. Back case 2 Attach the speaker systems to the monitor. Remove two screws on each side of the monitor Right side as shown and keep them for re-install. Loosen two screws on each side of the monitor as shown so that the speaker holders can be slide on to them. Insert the loosened screws into the engaging holes of the speaker holders that are Loosen screws Remove screws 8 attached to the speaker system, and slide the screws downwards. Next, use the previously- removed screws to fasten the speaker holders into the mounting holes in the monitor. Tighten Monitor rear side the four screws to secure. Speaker holder shown the other side SPEAKER TERMINAL (8Ω8W) Hook this section on the loosened screw Remove screws 3 4 Attach the connection cables to the speaker system. Attach the speaker connection cables to the monitor. Treating the wire ends Pull off while twisting Please prepare the supplied speaker cables. Speaker terminals Connect the copper-coloured wire to the + side Connect the silver-coloured wire to the - side - Black +Red 8 8 8 Connect Connect the silver- the coppercolour wire colour wire How to connect the speaker cables (Speaker side) Press down the lever with your finger Insert the wire Remove your finger Caution required Be sure to insert the speaker cables securely. Lock the connection terminal level securely. How to connect the speaker cables (Monitor side) Press the lever down Insert the wire Raise the lever