Hitachi 43GX10B Owners Guide - Page 27

USING THE REMOTE TO CONTROL DVD FUNCTIONS Operating the precoded function for your DVD Player. This remote is designed to operate different types of DVD Players. You must first program the remote to match the remote system of your DVD Player. (refer to page 29) 1. Turn ON your DVD Player. 2. Aim the remote control at the front of your DVD Player. 3. Press the DVD/VCR button to switch to the DVD Player pre-coded mode. 4. Hold down the DVD/VCR button on the remote, enter the two digit preset code that matches your DVD Player as shown on page 29. The remote will turn off your DVD Player when the correct two digit preset code is entered. When this occurs, the remote control is programmed for your DVD Player. If the DVD Player does not turn off after five seconds, try a different two digit preset code. 5. The remote will now control you DVD Player. POWER TV CBL/SAT DVD/VCR SWAP MOVE PIP FREEZE HELP PIP CH MENU DVD button This button allows the remote to control your DVD Player by setting it to DVD mode. EXCLUSIVE TV buttons These buttons are for operating the TV. SELECT MUTE EXIT LAST CH VOL CH 1 2 3 4 5 6 7 8 9 INPUT 0 STATUS REC TV/VCR PIX PRECODED DVD buttons These buttons always transmit the chosen precoded DVD codes. When the remote is in DVD mode, EXIT button is used as ENTER button. NOTES: 1. If your DVD Player cannot be operated after performing the above procedures, your DVD Player s code has not been pre- coded into the remote. 2. In the unlikely event that your DVD Player cannot be operated after performing the above procedures, please consult your DVD Player operating guide. 3. The remote control will remember the codes you have programmed until the batteries are removed from the remote control. After replacing the batteries repeat the entire programming procedure as stated above. NOTE: Refer to instruction manual of the DVD Player for operation of the buttons exclusively for the DVD Player. 27