Hitachi 50VX500 Owners Guide - Page 73
If Power Is Connected Before The Lamp Cover Is Installed, The Power Will, Be Off And The Lamp
View all Hitachi 50VX500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 73 highlights
LAMP REPLACEMENT LAMP REPLACEMENT 6. Without installing the lamp cover, the power will be off and the Lamp Indicator will flash (see page 8). Be sure to install the lamp cover by re-engaging the two clips and tighten the screws before turning the power on, otherwise it may cause unusual colors. SCREW LAMP COVER PHILLIP HEAD SCREW DRIVER NOTE: IF POWER IS CONNECTED BEFORE THE LAMP COVER IS INSTALLED, THE POWER WILL BE OFF AND THE LAMP INDICATOR WILL FLASH (SEE PAGE 8 ). 7. Install the front cover as shown below. Put the front cover back in and align the snap on quick connect then push inwards holding the left and right side of the front cover until you hear a snap. Push the other snap on gently to make a good fit. FRONT COVER PUSH PUSH 8. Plug power cord into AC outlet and turn on the main power switch. 120V NOTE: PUSH POWER The lamp in this product contains Mercury. Dispose of properly in accordance with applicable environmental laws. For Recycling and Disposal information, contact your respective governmental agencies or the Electronic Industries Alliance at www.eiae.org (in the U.S.) or Electronic Product Stewardship Canada at www.epsc.ca (in Canada). 73