Hitachi CMP4202U Owners Guide - Page 12

INSTALLATION INSTRUCTIONS (continued) Connecting to a Video Imaging Device (When the optional video unit is installed.) (1) Make sure that the power switch of the imaging device is turned off. (2) Use a commercially available cable and connector to connect the signal input terminal on the rear panel of this device and the signal output terminal of the imaging device. Speaker (R) Monitor rear panel Speaker (L) External Monitor To audio output terminals To component output terminals To audio/video output terminals To S video output terminals To component input terminals To S video input terminals To audio input terminals Power cable connector Video equipment (such as a video disc player, a DVD player, and a video camera) Power cable VIDEO 1 AUDIO IN COMPOSITE S R L/MONO R L/MONO IN OUT IN COMPONENT IN VIDEO 2 PR/CR PB/CB Y Use if the video equipment has an S video input terminal   COMPOSITE S IN OUT IN To composite input terminals To composite output terminals • If video equipment with an S video output terminal is used, cabling by the S video cable is recommended to provide finer video quality. (If an S video input terminal and a video input terminal connect to the monitor at the same time, S video input would govern.) • If the VIDEO1 OUT terminal is connected to an external monitor with a 75 Ohm terminal, it is possible to view the same image as on the main unit. If an external monitor is not being used, the cable must be removed from the VIDEO OUT terminal. The image will appear white as saturation level is reached. With RGB component setup RS232C RGB 2 D-SUB IN RGB 1 D-SUB IN AUDIO IN To component video ˎ equipment. ˎ Please use the connection cable suitable for the terminal form of video equipment. Speaker Connection This device is equipped with speaker output jacks for use in connecting a speaker system (optional). Refer to the diagram below to connect. 10̼̼ Remove the insulation and twist the bare cable as shown. Down the tab and insert the cable. Press the tab up to prevent the cable being pulled out. With SCART terminal connection (refer to  ) VIDEO 1 AUDIO IN COMPOSITE S R L/MONO R L/MONO IN OUT IN COMPONENT IN VIDEO 2 PR/CR PB/CB Y Video equipment  CAUTIONS When connecting speakers, connect the plus (+) speaker terminal and the plus (+) speaker terminal of this device, and connect the respective minus (-) terminal in the same way. The sound will not be correct if plus (+) and minus (-) terminal are connected to each other.