Hitachi CPS240 Quick Start Guide - Page 7
Operating - lamp
UPC - 050585160781
View all Hitachi CPS240 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
ENGLISH Operating Operating WARNING ►When the power is on, a strong light is emitted. Do not look into the lens of projector. Also do not peep at the inside of projector through a hole. Turning on the power 1. Set the power switch to the ON position. POWER (Steady orange) 2. Press the STANDBY/ON (projector or remote control) button. POWER POWER (Blinking in green) (Steady green) Displaying 1. To select an input signal, use the button of INPUT (projector), or the buttons of RGB, VIDEO or SEARCH (remote control). 2. To change the aspect ratio, use the button ASPECT (remote control). Focus ring Zoom knob 3. To adjust the zoom and focus, use the zoom knob and the focus ring. Turning off the power This product is able to turn off the main power during the cooling. However, please pay special attention to below two points when you do: (1) Please do not turn the projector on again for at least 1 minute in this case. Neglect could shorten the lifetime of the lamp. (2) During use or immediately after use, do not touch around the lamp and vents of the projector. It could cause a burn. 1. Press the STANDBY/ON (projector or remote control) button. The message "Power off?" will appear on the screen for approximately 5 seconds. 2. Press the STANDBY/ON (projector or remote control) button again while the message appears. The projector lamp will go off, and the POWER POWER indicator will begin blinking in orange. Then the (Blinking in orange) POWER indicator will stop blinking and light in steady orange when the lamp cooling is complete. POWER (Steady orange) 3. Make sure that the power indicator lights in steady orange, and set the power switch to the OFF position. The POWER indicator will go off. 7