Hitachi DV18DLP4 Instruction Manual - Page 20
Installing/Removing the side handle, Mounting and dismounting the bit
UPC - 717709011984
View all Hitachi DV18DLP4 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
English (1) Removing the bit Securely hold the main unit and pull out the bit by holding the tip with your thumb. (Fig. 13) (2) Installing the Bit Install the bit with steps opposite of when removing. Insert the bit so that the right and left sides are equal, as shown in Fig. 14. 3. Installing/Removing the side handle Insert so that bit does not protrude from main unit CAUTION: ● Firmly install the side handle. If loose, the side handle may gyrate or fall out and cause bodily injury. (1) Install the side handle so that the protrusions on the main unit and grooves on the side handle interlock. Tighten the grip after checking that the side handle is not riding on the slip prevention protrusion. (Fig. 15) (2) Loosen the grip to remove the side handle. 4. Mounting and dismounting the bit (1) Mounting the bit Loosen the sleeve by turning it toward the left (in the counterclockwise direction as viewed from the front) to open the clip on the keyless chuck. After inserting a driver bit, etc., into the keyless drill chuck, and tighten the sleeve by turning it toward the right (in the clockwise direction as viewed from the front). (See Fig. 16) Fig. 14 Concave Rotate preventing protrusion Side handle Loosen Grip Slip preventing protrusion Tighten Fig. 15 Loosen Sleeve NOTE: If the sleeve becomes loose during operation, tighten it further. The tightening force becomes stronger when the sleeve is tightened. Tighten Fig. 16 (2) Dismounting the bit Loosen the sleeve by turning it toward the left (in the counterclockwise direction as viewed from the front), and then take out the bit, etc. (See Fig. 17) NOTE: If the sleeve is tightened in a state where the clip of the keyless chuck is opened to a maximum limit, a click noise may occur. This is the noise that occurs when the loosening of the keyless chuck is prevented and is not a malfunction. CAUTION: When mounting a bit into the keyless chuck, tighten firmly. If the sleeve is not tight, the bit may slip or fall out, causing injury. 20