Hitachi Wrench3.0 Instruction Manual - Page 8
Assembly And Operation
View all Hitachi Wrench3.0 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
English ASSEMBLY AND OPERATION REMOVAL AND INSTALLATION METHOD OF BATTERY ⅜ How to install the battery Align the battery with the groove in tool handle and slip it into place. Always insert it all the way until it locks in place with a little click. If not, Handle it may accidentally fall out of the tool, causing injury to you or someone around you. (Fig. 1) ⅜ How to remove the battery Withdraw battery from the tool handle while pressing the latch on the Battery side of the battery. (Fig. 1) Latch Insert CHARGING METHOD Pull out NOTE: Before plugging into the receptacle, make sure the following points. ⅜ The power source voltage is stated on the nameplate. ⅜ The cord is not damaged. Fig. 1 WARNING: Do not charge at voltage higher than indicated on the nameplate. If charged at voltage higher than indicated on the nameplate, the charger will burn up. 〈UC14YFA, UC24YFA, UC18YRL〉 1. Insert the plug of battery charger into the receptacle When the plug of battery charger has been inserted into the receptacle, pilot lamp will blink in red. (At 1-second intervals) WARNING: Do not use the electrical cord if damaged. Have it repaired immediately. 2. Insert the battery to the battery charger Insert the battery into the battery charger. Make sure it contacts the bottom of the battery charger. CAUTION: ● If the batteries are inserted in the reverse direction, not only recharging will become impossible, but it may also cause problems in the charger such as a deformed recharging terminal. 3. Charging When the battery is connected to the battery charger, charging will commence and the pilot lamp will light in red. (See Table 2) NOTE: If the pilot lamp flickers in red, pull out the plug from the receptacle and check if the battery is properly mounted. When the battery is fully charged, the pilot lamp will blink in red slowly. (At 1-second intervals) (See Table 2) (1) Pilot lamp indication The indications of the pilot lamp will be as shown in Table 2, according to the condition of the charger or the rechargeable battery. Table 2 Indications of the lamps Before charging Blinks (RED) Lights for 0.5 seconds. Does not light for 0.5 seconds. (off for 0.5 seconds) While charging Charging complete Lights (RED) Blinks (RED) Lights continuously Lights for 0.5 seconds. Does not light for 0.5 seconds. (off for 0.5 seconds) Charging impossible Flickers (RED) Lights for 0.1 seconds. Does not light for 0.1 seconds. (off for 0.1 seconds) Malfunction in the battery or the charger. Charging impossible Lights (GREEN) Lights continuously The battery temperature is high, making recharging impossible. NOTE: When standby for cooling battery, UC18YRL cools the overheated battery by cooling fan. 8