Homelite UT10549 User Manual - Page 35
Cleaning The Engine, Warning
View all Homelite UT10549 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
MAINTENANCE CLEANING THE ENGINE See Figures 65 - 68. Clean the cylinder fins and flywheel fins with compressed air or a brush periodically. Dangerous overheating of the engine may occur due to impurities on the cylinder. FRONT HAND GUARD SCREW FUEL CAP CHAIN OIL CAP WARNING Never run the saw without all the parts, including the clutch cover and starter housing, securely in place. Because parts can fracture and pose a danger of thrown objects, leave repairs of the flywheel and clutch to factory trained authorized service center personnel. Failure to follow these instructions could result in serious personal injury. n Remove the screws and cylinder cover as described previously. n Clean the cylinder fins. n Remove the screw from the front hand guard post. n Lift the front hand guard over the post. n Lay the chain saw on its side with the bar and chain on the ground. n Remove the chain oil and fuel caps. n Remove the three screws that hold the starter housing in place. n Lift off the starter cover and set aside. n Replace chain oil and fuel caps to prevent con- tamination during cleaning. n Clean the flywheel fins. n Remove the chain oil and fuel caps. n Replace the starter housing. Reinstall screws and secure. n Replace the chain oil and fuel caps. n Replace the cylinder cover. Reinstall screws and secure. NOTE: Check to ensure that the air filter is in the proper position before reinstalling the cylinder cover. n Replace the front hand guard on the post. n Reinstall screw into front hand guard post; tighten securely. POST STARTER COVER Fig. 66 CLEAN CYLINDER FINS Fig. 67 CLEAN FLYWHEEL FINS Fig. 68 Page 35 - English