Homelite UT10589 Getting Started Guide

HOW TO GET STARTED

988000564

3-9-12 (REV: 02)

Make The Most Of Your Purchase!

For any questions about operating or maintaining your product, call the Homelite

Help Line !

Your Product has been fully tested prior to shipment to ensure your complete satisfaction.

Troubleshooting tips are available in your operator's manual.

Go to

www.homelite.com

and register your new tool on-line.

IMPORTANT: It is normal for chain saws to have bar and chain lubricant under the chassis after operating

the saw. This bar and chain lubricant is coming from the clutch cover area and is NOT an indication of a

leak. The clutch cover area must be saturated with lubricant to properly lubricate the bar and chain and

to ensure the long-term durability of your new chain saw.

1

Press fully and release

PRIMER BULB 7 times.

9

10

Add bar lubricant to oil tank.

Set ignition switch to

RUN (I) position.

Pull CHOKE lever to the

FULL position.

DEPRESS throttle release

then SQUEEZE and release throttle trigger.

Pull STARTER grip and rope until

engine runs.

1 GALLON

GAS

2

3

4

5

6

Above 50

º

F - Pull STARTER 3 times

Below 50

º

F - Pull STARTER 5 times

7

8

Push choke lever to

RUN position.

x7