Homelite UT13120 User Manual - Page 17
Call Us First
View all Homelite UT13120 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
TROUBLESHOOTING Problem Handle not in position. Mower not starting. Mower cutting grass unevenly. Mower not mulching properly. Mower hard to push. Mower vibrating at higher speed. Possible Cause Solution Carriage bolts not seated properly. Handle knobs not tightened. Adjust the height of the handle and make sure the carriage bolts are seated properly. Tighten handle knobs. Extension cord not connected to the mower plug. Extension cord not connected to power source. Tripped circuit breaker in the house. Motor control switch defective. Reconnect the cord and use the cord retainer to keep the cord close to the motor/blade control. Connect the extension cord to a live 120V AC, 60 HZ AC receptacle. Reset house circuit breaker. If it trips again, call a qualified electrician. Have motor control switch replaced by an authorized service center. Lawn is rough or uneven or cutting height not set properly. Move the wheels to a higher position. All wheels must be placed in the same cutting height for the mower to cut evenly. Wet grass clippings sticking to the Wait until the grass dries before underside of the deck. mowing. High grass, rear of mower housing and blade dragging in heavy grass, or cutting height too low. Raise cutting height. Blade is unbalanced. Bent motor shaft. Balance the blade by grinding each cutting edge equally. Stop the motor, disconnect the power source, and inspect for damage. Have repaired by an authorized service center before restarting. CALL US FIRST For any questions about operating or maintaining your product, call the Homelite® Help Line! Your product has been fully tested prior to shipment to ensure your complete satisfaction. Page 17