Homelite UT26HBV Engine Starting Procedure

Homelite UT26HBV Manual

Homelite UT26HBV manual content summary:

  • Homelite UT26HBV | Engine Starting Procedure - Page 1
    throttle/cruise control lever. Pull starter grip and rope until engine starts. 1 2 Make The Most Of Your Purchase! NOTICE: Homelite® Help Line! Your Product has been fully tested prior to shipment to ensure your complete satisfaction.Troubleshooting tips are available in your operator's manual
  • Homelite UT26HBV | Engine Starting Procedure - Page 2
    manual del operador. Para reducir el riesgo de lesiones, el usuario debe leer y comprender el manual veces como máximo.) 2 6 Mettre le volet de départ en position HALF CHOKE (demi étranglement). Coloque la palanca du produit, appeler le service d'assistance téléphonique Homelite ! Ce produit à
  • 1
  • 2

991000663
2-3-16 (REV:01)
Make The Most Of Your Purchase!
Go to www.homelite.com and register your new tool on-line.
For any questions about operating or maintaining your product, call the
Homelite® Help Line! Your Product has been fully tested prior to shipment to ensure
your complete satisfaction.Troubleshooting tips are available in your operator’s manual.
WARNING:
This Engine Starting Procedure is not a substitute for reading
the operator’s manual. To reduce the risk of injury, user must read and understand
operator’s manual before using this product.
Slowly press the PRIMER BULB 10x or until fuel appears.
Pull starter grip and rope until engine attempts
to start (4X max.)
ENGINE STARTING PROCEDURE
TO START:
1
2
3
4
5
PRESS and HOLD stop switch until
engine stops.
TO STOP:
Lock throttle/cruise control lever.
SET choke lever to FULL choke.
6
SET choke lever to HALF choke.
Pull starter grip and rope until engine starts (6X max.)
NOTE: If the unit has not started, return to step 3.
7
8
Allow the engine to warm for 10 seconds,
SET choke lever to RUN.
TO RESTART A HOT ENGINE:
If the engine/unit is already hot:
Lock throttle/cruise control lever.
SET choke lever to RUN.
Pull starter grip and rope until engine starts.
9
2
4
1
3
6
8
5
7
9
50:1 Ratio = Mix 2.6 oz 2-cycle oil with
1 gallon of fresh gasoline in separate gas
container. SHAKE. Pour into fuel tank.
1 GALLON
GAS
2.6
oz.
NOTICE:
Do not use E15 or E85 fuel in this
product. It is a violation of federal law and
will damage the unit and void your warran-
ty. Only use unleaded gasoline containing
up to 10% ethanol.