Honeywell 5804BD User Manual - Page 1
Honeywell 5804BD Manual
View all Honeywell 5804BD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
N8547V1 04/09 5804BD TWO-WAY WIRELESS KEY USER GUIDE About 5804BD 5804BD is a four-button remote control for your alarm system. 5804BD can send a command to the alarm system, such as to arm or disarm, as well as receive system status. Two LEDs and a speaker are used to indicate system status. 5804BD is typically used for arming, disarming, and controlling devices. Check with your installer to understand which functions the buttons have been assigned on your unit. Operating the Buttons Activating a Button To activate a function, press and hold the appropriate button down until the yellow LED flashes (2 beeps will be heard), and then release it. NOTE: Transmission will not be successful if the key is not within range of the system's receiver. If 5804BD does not receive system status from the panel for approximately five seconds, it will generate a long (one second) beep. Requesting System Status You can check system status before arming or disarming your system. Check the system status by momentarily pressing and releasing any button. The yellow LED will flash after you release the button (one beep will be heard). After a second or two, the device will display the system status through the LEDs and speaker (see the System Status Indications Table, below). If 5804BD does not receive system status from the panel for approximately five seconds, it will generate a long (one second) beep and shut itself down. It will also shut itself down if you do not press a button within five seconds of receiving a status update. System Status Indications Table LED LED Condition Sounds System Status Red On Steady 2 Beeps Armed Away or Maximum On Steady Flashing 3 Beeps Pulsing Armed Stay or Instant Fire Alarm in progress Flashing Steady Armed, Burglary Alarm in progress Yellow (right) Flashing Flashing Silent Silent Alarm Memory Indicates RF transmission Red & Green Green Alternately Flashing On Steady Silent 1 Beep In Enter House ID Mode Disarmed, Ready to Arm Flashing Silent Disarmed, Not Ready to Arm Flashing Flashing Pulsing 1 Beep System in Trouble Condition System Not Ready Multiple Button Operations The 5804BD can generate the same responses as keypad key pairs of [*] + [#] and [*] + [1] by depressing "A" + "C" and "B" + "D" button pairs, respectively. You must depress the button pair for at least 2 seconds for the 5804BD to recognize the button pair command. These button pairs allow you to activate additional keypad functions depending on control panel programming. Check with your installer to understand which functions the buttons have been assigned on your unit.