Honeywell CT1500 Owner's Manual

Honeywell CT1500 Manual

Get Honeywell CT1500 PDF manuals and user guides View all Honeywell CT1500 manuals
Add to My Manuals
Save this manual to your list of manuals

Honeywell CT1500 manual content summary:

  • Honeywell CT1500 | Owner's Manual - Page 1
    CTl500, CT1501, CT1502, CT1503 ELECTROMECHANICAL FUEL SAVER THERMOSTAT AND WALLPLATEEUBBASE CTI500-24 V gas ON LINE VOLTAGE (120 V) SYSTEMS. INSTALLATION MANUAL Any questionsconcerningthe applicationofthis thermostat should be directedto HoneywellConsumer Services at 1-800-468-1502, Monday-Friday 7
  • Honeywell CT1500 | Owner's Manual - Page 2
    1 CONTROL LEVER (RED) LOW TEMPERATURE CONTROL LEVER (BLUE)- Ill-Cover removed. 24 HOUR PROGRAM DIAL 'THERMOSTAT COVER THERMOMETER 1 11.711 Il-Hinged cover lifted. .. .~ . ,..... . PROGRAM PINS A "--- CAPTIVE MOUNTING ANTICIPATOR HIND THERMOSTAT. H E L D O N BY TWO CAPTIVE SCREWS.)
  • Honeywell CT1500 | Owner's Manual - Page 3
    "1k PREPARATION ((1 THERMOSTAT MODEL SUBBASE OR WALLPLATE INCLUDED FOR USE WITH CT1500 199986C Wallplate 2-wire, 15 to 30 volt control circuit For gas or oil heating system. CT1501 Q682A1079 Subbase 4- or 5-wire, 15 to 30 volt control circuit For gas or oil heating/cooling system. CT1502
  • Honeywell CT1500 | Owner's Manual - Page 4
    and Adapter Ring (see appropriate figure under step 4). Call Honeywell Consumer Services (1-800-468-1502) for ordering information, Monday-Friday, 7:30 i2 F UNPACK THERMOSTAT 0 0Remove and discard shipping wrap. Save package of screws, instructions and receipt Remove thermostat cover by lifting
  • Honeywell CT1500 | Owner's Manual - Page 5
    on a system with B or 0 terminals. One or two extra wires? If you are replacing a Honeywell Chronotherm thermostat,you may find one or two wires that go to the clock terminals on the Chronotherm thermostat wiring wallplate. Do not allow them to touch, or you may damage your transformer. Disconnect
  • Honeywell CT1500 | Owner's Manual - Page 6
    "4 b MOUNT WALLPLATE OR SUBBASE 10 If mounting on outlet box, mount as shown on appropriate figure. bIfamseoui.nnti'pnogsoi.tn.ionwaalln, dhomldarwkahlloplleasteoonr subwall. Use spirit level to make sure wallplate or sub- base will be level. Drill 3/16 in. holes and gently tap anchors into
  • Honeywell CT1500 | Owner's Manual - Page 7
    nCarefully level the wallplate or subbase and firmly u tighten screws. .. SPIRIT LEVEL ''wm WALLPLATE SCREWS "2) 5 69-0273-9
  • Honeywell CT1500 | Owner's Manual - Page 8
    WALLPLATE OR SUBBASE 0 .: -MOTE:All wiring must comply with local electrical codes and ordinances. Refer to illustration and strip thermostat wire insulation as necessary. - F. "-r.n.~S.T.F..ldilR.U.T CONNECTION- For CT1500 heating-only 0 , FOR WRAPAROUND CONNECTIONSTRlP7116In. [11 mml BARRIER
  • Honeywell CT1500 | Owner's Manual - Page 9
    For CT1501 heating/cooling Connect the wires to matching terminals on the subbase. 5-WIRE SYSTEM I 4-WIRE SYSTEM U U I I RELAY OR VALVE COIL I I CONTACTOR I I I 1 POWER SUPPLY. PROVIDE DISCONNECT MEANS AND M2&13 NOTE: If there are four wires, connect wire marked R to terminal RH and add a
  • Honeywell CT1500 | Owner's Manual - Page 10
    control Push excess wire back into wall. and plug hole in wall with nonflammable insulation to prevent drafts from affecting thermostat operation. For CT1502 heatinglcooling CENTRAL ELECTRIC SYSTEM I - I 1 II U CONTACTOR RELAY OR VALVE COIL A POWER SUPPLY. PROVIDE DISCONNECT MEANSAND OVERLOAD
  • Honeywell CT1500 | Owner's Manual - Page 11
    excess wire back into wall, and plug hole in wall with nonflammable insulation to prevent drafts from affecting thermostat operation. 0 + L' (HOT) u+ A POWER SUPPLY PROVIDE DISCONNECT MEANS AND OVERLOPD PROTECTION AS REQUIRED A IFCOMPRESSOR ISCONNECTEDTO OLDTHERMOSTATS "YTERMINALWITH A JUMPERTO
  • Honeywell CT1500 | Owner's Manual - Page 12
    - L MOUNT THE THERMOSTAT or subbase as shown in illustration. Do NOT cycle heating system until Step 7 is completed. 10
  • Honeywell CT1500 | Owner's Manual - Page 13
    control the on-time length of the system. An incorrect setting can result in room temperature swings or burn out the anticipator and void the thermostat warranty. Make sure you have the current draw (anticipator setting) for your system. This i s the number you wrote in the box in Step 3 If you
  • Honeywell CT1500 | Owner's Manual - Page 14
    On the CT1500. CT1501 or CT1502 thermostats, move the heat anticipator indicator to match the number you recorded in Step 4 or found on the primary control as shown above, or as recorded in Step 7 "8INSTALL F TIMER BATTERIES 0 \ANTICIPATOR SETTING LEVER 11,7164\ teries in thermostat as shown.
  • Honeywell CT1500 | Owner's Manual - Page 15
    SET TIMER 0Adjust the timer by moving the knob in clockwise direction. Do NOT reverse the knob. When time is correctly set, the Time Indicator Arrow (see illustration) must point to the correct time and the corresponding daytime (lighr) or nighitime (dark) portion of the program dial. 13
  • Honeywell CT1500 | Owner's Manual - Page 16
    "10 0I- ATTACH THERMOSTAT COVER 0Make sure the packing inserts in the thermostat base have been removed. as explained in step 3 0Place the two tabs on upper edge of cover into mounting slots in thermostat base 0Swing cover downward until it engages catch at bottom of base .. 14
  • Honeywell CT1500 | Owner's Manual - Page 17
    OPERATION AND SET b TEMPERATURE CONTROL LEVERS The two levers on top of the thermostat control the low and high temperature for energy savings and comfort control, as shown in illustration. LOW TEMP.lBL"E MARK1 SET LEVER 1 Do NOT check
  • Honeywell CT1500 | Owner's Manual - Page 18
    . The heat should shut off. 0 Operate the entire heating system for at least one complete cycle. IMPORTANT If thermostat fails any test, refer to troubleshooting guide in owner's manual. Heating/Cooling System 0 Turn on power to the furnace and cooling system. 0 Place the system switch lever at
  • Honeywell CT1500 | Owner's Manual - Page 19
    you wantfor normal comfort periods. REFER TO THE OWNERS MANUAL FORM 690333FOR OPERATING AND PROGRAMMING INSTRUCTIONS. IF YOU HAVE OUESTIONS REGARDING THE INSTALLATION OF THE HONEYWELL FUEL SAVER THERMOSTAT, PLEASECALL OUR TOLLFREE CONSUMER SERVICES GROUP NUMBER AT 1-800-468-1502, MONDAY-FRIDAY, 7:30
  • Honeywell CT1500 | Owner's Manual - Page 20
    Residential and Building Controls Division Honeywell Inc. 1985 Douglas Drive No. Golden Valley, MN 55422 Residential and Building Controls Division Honeywell Limited-Honeywell 740 Ellesmere Road Scarborough, Ontario M1P 2VY Lunltke Honeywell Helping You Conlrol Your World
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
CTl500, CT1501,
CT1502,
CT1503
ELECTROMECHANICAL FUEL SAVER
THERMOSTAT AND
WALLPLATEEUBBASE
CTI500-24
V
gas
or
oil heat.
CTl501-24
V
gas
or
oil
heat/cool.
CTI502--24
V
central electric heat/cool
or
single stage heat
pump
without
auxiliary heat.
CTI
503-750
millivolt heat.
NOT
FOR USE
ON LINE VOLTAGE (120
V)
SYSTEMS.
INSTALLATION MANUAL
Any questions concerning the application
of
this thermostat should be directed to HoneywellConsumer Services
at
1-800-468-1502,
Monday-Friday
730
a.m.-500 pm., Central time.
S.M.
Rev.
7-91
aHoneywell
Inc.
1991
Form
Number
69-0273-9