Honeywell IS215TCE Installation Instructions
Honeywell IS215TCE Manual
 |
View all Honeywell IS215TCE manuals
Add to My Manuals
Save this manual to your list of manuals |
Honeywell IS215TCE manual content summary:
- Honeywell IS215TCE | Installation Instructions - Page 1
/ LOCALIZACIÓN 2 OPEN / OPENEN / OUVERTURE / APERTO / ABIERTO 2.3m - 2.7m (7.5ft - 9ft) 5 4 3 IntelliSense IS215TCE-MIC Passive Infrared Motion Sensor - Installation Instruction 1 2 3 MOUNT / MONTAGE / INSTALLATION / MONTAGGIO / MONTAJE 4 WIRE / AANSLUITEN / CABLAGE / COLLEGAMENTO / CABLEADO - Honeywell IS215TCE | Installation Instructions - Page 2
IntelliSense IS215TCE-MIC Passive Infrared Motion Sensor - Installation Instruction LED OPERATION LED Indication Condition S1 ON S1 OFF warm up slow blink slow blink (2 minutes) normal off off alarm on for 3 off seconds trouble fast blink fast blink Relay closed closed open for 3 - Honeywell IS215TCE | Installation Instructions - Page 3
IntelliSense IS215TCE-MIC Passive Infrared Motion Sensor - Installation Instruction SIA PIR-01, Passive Infrared detector standard security.honeywell.com/hsce/international generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions circuit - Honeywell IS215TCE | Installation Instructions - Page 4
IntelliSense IS215TCE-MIC Passive Infrared Motion Sensor - Installation Instruction 2007 Honeywell International Inc. Honeywell and IntelliSense are registered trademarks of Honeywell International Inc. All other trademarks are the properties of their respective owners. All rights reserved. Made
-
1 -
2 -
3 -
4
 |
 |
IntelliSense
IS215TCE-MIC Passive Infrared Motion Sensor - Installation Instruction
2.3m - 2.7m
(7.5ft - 9ft)
4
1
3
5
+12 VDC, 18mA
24 VDC, 30mA
LED ENABLE
ON
2
1
H
L
H
L
H
L
1 - 3
3 - 5
M
G
+
24 VDC, 30mA
T
T
C
NC
_
NC
2
NC
1
2
WIRE / AANSLUITEN / CABLAGE / COLLEGAMENTO /
CABLEADO
SET / INSTELLEN / CONFIGURATION / IMPOSTARE LE
RGEGOLAZIONI / PROGRAMACION
J1
+
+
M
G
M
G
J1
J1
L = Low (pulse count 2)
L = Laag (pulscount 2)
L = Basse (comptage
d'impulsion à 2)
L = Bassa (contaimpulsi 2)
L = Baja (contador de
pulsos 2)
H = High (pulse count 1)
H = Hoog (pulscount 1)
H = Haute (comptage
d'impulsion à 1)
H = Alta (contaimpulsi 1)
H = Alta (contador de
pulsos 1)
5
4
3
OPEN / OPENEN / OUVERTURE / APERTO / ABIERTO
J1
MIC
LED
0.3-1.0mm
2
(22-18 AWG)
LOCATION / LOCATIE / EMPLACEMENT / POSIZIONE / LOCALIZACIÓN
MOUNT / MONTAGE / INSTALLATION /
MONTAGGIO / MONTAJE