Honeywell TH1100D1001 Owner's Manual - Page 13
In case of difficulty
View all Honeywell TH1100D1001 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
ENGLISH PRO 1000 Series In case of difficulty Screen is blank. Temperature settings cannot be changed. Cool On or Heat On is flashing. HI appears on the screen. LO appears on the screen. E1 appears on the screen. E2 appears on the screen. • Check circuit breaker and reset if necessary. • Ensure the heating/cooling system is powered up. • Ensure the furnace door is properly closed. • Ensure two fresh AAA alkaline batteries are correctly installed. • The System switch is off. • You are setting the temperatures outside their allowable ranges: • Heat: 40 °F to 90 °F (4.5 °C to 32 °C). • Cool: 50 °F to 99 °F (10 °C to 37 °C). • The compressor protection delay has been activated. Wait for the delay to end (maximum of 5 minutes). • The ambient (measured) temperature is above 122 °F (50 °C). • The ambient (measured) temperature is below 32 °F (0 °C). • The temperature sensor circuit is opened. Replace the thermostat. • The temperature sensor circuit is shorted. Replace the thermostat. 9