Hoover U2440 Manual - Page 11
Lubrication, The agitator brush roll
View all Hoover U2440 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
3-21 3-22 3-23 H Slide belt over motor shaft (H). Align belt between "U" shaped posts. Reposition hood and replace 2 hood screws. With bottom of cleaner facing up, replace 2 bottom screws. 3-24 The agitator brush roll When to replace When agitator brush roll brushes are worn, the agitator brush roll should be replaced. Disconnect cleaner from electrical outlet. WARNING: Agitator brush roll can start suddenly. Unplug cleaner before turning it over. What to buy When purchasing a new agitator, ask for HOOVER part No. 2BEA131001900. To check condition of brushes, move edge of a card across bottom plate while turning agitator brush roll. To maintain cleaning effectiveness, replace agitator brush roll if brushes do not touch card. To remove agitator, follow Items 3-11 through 3-16. Install new agitator brush roll following Items 3-19 through 3-23. Lubrication The motor is equipped with bearings that contain sufficient lubrication for the life of the motor. The addition of lubricant could cause damage. Therefore, do not add lubricant to motor bearings. The agitator brush roll is equipped with two ball bearings that should be lubricated periodically by a Hoover Sales and Service Center or an Authorized Hoover Warranty Service Dealer. Continued § 11