Hoover UH70210 Manual - Page 13

Belt (continued) What to Buy: Belt Use only genuine HOOVER® belts with your vacuum. When purchasing a new belt for models with Brushroll On/Off (Suction Only Mode), ask for Flat Belt - HOOVER® part No. 562289001 or AH20065. When purchasing a new belt for models without Brushroll On/Off (Suction Only Mode), ask for Stretch Belt - HOOVER® part No. 38528058 or AH20080. If desired, additional belts can be purchased at Hoover.com or 1-800-944-9200 4.28 With lettering on outside of belt, slide new belt over motor shaft (metal rod) (E). Push other end of belt through belt guide (F) and over metal pulley*, then slip around area of brushroll without bristles (G). With belt in place, pull and slide brushroll into nozzle making sure that the brushroll end caps are in the correct orientation. 4.29 Reposition bottom plate, aligning the three tabs along front edge of nozzle guard with the three slots in nozzle. Rotate back into position. Slide red lower latch to Lock position, and rotate red upper latch clockwise to secure bottom plate. *Models without "Suction Only Mode" do not have the metal pulley 4.28 F 4.29 E G IMPORTANT Rotate brushroll manually to make sure belt is not twisted. 13 Actual model may vary from images shown.