Hotpoint GSM1860NSS Use and Care Manual / Warranty - Page 7
Using the dishwasher., Use Jet-Dry, or Cascade Crystal Clear, Rinse Agent - instructions
View all Hotpoint GSM1860NSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Safety Instructions Operating Instructions Using the dishwasher. ge.com Check the Water Temperature The entering water should be at least 120°F and not more than 150°F, for effective cleaning and to prevent dish damage. Check the water temperature with a candy or meat thermometer. Turn on the hot water faucet nearest the dishwasher, place the thermometer in a glass and let the water run continuously into the glass until the temperature stops rising. Use Jet-Dry® or Cascade Crystal Clear® Rinse Agent Jet-Dry® or Cascade Crystal Clear® rinse agent removes spots and prevents new film buildup on your dishes, glasses, flatware, cookware and plastic. Filling the Dispenser The rinse agent dispenser holds 3.5 oz. of rinse agent. Under normal conditions, this will last approximately one month. Try to keep it full, but do not overfill. Indicator 1 Make sure the dishwasher door is fully open. 2 Turn the dispenser cap to the left and lift it out. 3 Add rinse agent until the indicator window looks full. 4 Clean up any spilled rinse agent with a damp cloth. 5 Replace the dispenser cap. n M Mi ax Adjustable setting Dispenser cap Rinse Aid Setting The amount of rinse agent released into the final wash can be adjusted. The factory setting is at the midpoint. If there are rings of calcium (hard water) spots on dishes, try a higher setting. If you observe foam in the final rinse, try a lower setting. To adjust the setting Remove the dispenser knob; then turn the adjuster counterclockwise to increase the amount of rinse agent or clockwise to reduce the amount of rinse agent dispensed. Troubleshooting Tips Consumer Support 7