Hotpoint HLD4040NSA Owners Manual - Page 6

Customer Service, Troubleshooting Tips, Operating Instructions, Safety Instructions, Installation

Page 6 highlights

Troubleshooting Tips Installation Instructions Operating Instructions Safety Instructions About the dishwasher control panel. (For models without a sensor: EDW4000 Series, EDW5000 Series, GHDA400 Series, GLD4000 Series, GLD5000 Series, HLD4000 Series, GLDE400 Series and GLDE500 Series) You can locate your model number on the tub wall just inside the door. Throughout this manual, features and appearance may vary from your model. 1 2 4 3 Control Settings 1 Status Indicator Lights The Status display tells you what's happening while the dishwasher is in operation and may flash, indicating a malfunction. The lights will come ON indicating the sequence of operation the dishwasher is in. SANITIZED (on some models) CLEAN (on some models) Displayed when cycle has met sanitization conditions. Light remains ON until door is opened. Displayed when a wash cycle is complete. The light stays ON as a reminder that the dishes are clean until the door is opened or until another cycle is selected. 2 Cycles The light above the selected pad will be ON to indicate which cycle has been selected. SANI WASH (on some models) 7.3 gal., 97 min. This cycle raises the water temperature in the final rinse to sanitize your dishware. The cycle length will vary depending on the temperature of your inlet water. NOTE: The SANI-WASH cycle is monitored for sanitization requirements. If the cycle is interrupted during or after the main wash portion or if the incoming water temperature is so low that adequate water heating cannot be achieved, the sanitizing conditions may not be met. In these cases, the sanitized light will not illuminate at the end of the cycle. NOTE: NSF certified residential dishwashers are not intended for licensed food establishments. POTS & PANS or HEAVY WASH 8.5 gal., 89 min. This cycle is meant for heavily soiled dishes or cookware with dried-on or bakedon soils. Everyday dishes are safe to be used in this cycle. NORMAL WASH 5.9 gal., 56 min. This cycle is for medium/heavily soiled dishes and glassware. ECO WASH (on some models) 4.8 gal., 55 min. This cycle is for everyday dishes and glassware. LIGHT WASH (on some models) 6.1 gal., 36 min. This cycle is for everyday dishes and glassware. CHINA CRYSTAL 6.1 gal., 39 min. (on some This cycle is for lightly soiled china and crystal. models) RINSE ONLY 1.2 gal., 6 min. For rinsing partial loads that will be washed later. Do not use detergent with this cycle. 6 NOTE: Only the SANI-WASH cycle has been designed to meet the requirements of Section 6, NSF 184 for soil removal and sanitization efficacy. Customer Service

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18

6
Customer Service
Troubleshooting Tips
Operating Instructions
Safety Instructions
Installation Instructions
Customer Service
Troubleshooting Tips
Installation Instructions
Safety Instructions
Operating Instructions
Customer Service
Troubleshooting Tips
Installation Instructions
Safety Instructions
Operating Instructions
About the dishwasher control panel.
(For models without a sensor: EDW4000 Series,
EDW5000 Series, GHDA400 Series, GLD4000 Series, GLD5000 Series, HLD4000 Series, GLDE400 Series and GLDE500 Series)
You can locate your model number on the tub wall just inside the door.
Throughout this manual, features and
appearance may vary from your model.
Control Settings
Status Indicator Lights
The Status display tells you what’s happening while the dishwasher is in operation and may flash, indicating a
malfunction. The lights will come
ON
indicating the sequence of operation the dishwasher is in.
SANITIZED
Displayed when cycle has met sanitization conditions. Light remains
ON
until
(on some
door is opened.
models)
CLEAN
Displayed when a wash cycle is complete. The light stays
ON
as a reminder that
(on some
the dishes are clean until the door is opened or until another cycle is selected.
models)
Cycles
The light above the selected pad will be
ON
to indicate which cycle has been selected.
SANI WASH
7.3 gal., 97 min.
(on some
This cycle raises the water temperature in the final rinse to sanitize your dishware.
models)
The cycle length will vary depending on the temperature of your inlet water.
NOTE:
The
SANI-WASH
cycle is monitored for sanitization requirements. If the cycle is
interrupted during or after the main wash portion or if the incoming water temperature is
so low that adequate water heating cannot be achieved, the sanitizing conditions may
not be met. In these cases, the sanitized light will not illuminate at the end of the cycle.
NOTE:
NSF certified residential dishwashers are not intended for licensed food establishments.
POTS & PANS
8.5 gal., 89 min.
or
HEAVY
This cycle is meant for heavily soiled dishes or cookware with dried-on or baked-
WASH
on soils. Everyday dishes are safe to be used in this cycle.
NORMAL WASH
5.9 gal., 56 min.
This cycle is for medium/heavily soiled dishes and glassware.
ECO WASH
4.8 gal., 55 min.
(on some
This cycle is for everyday dishes and glassware.
models)
LIGHT WASH
6.1 gal., 36 min.
(on some
This cycle is for everyday dishes and glassware.
models)
CHINA CRYSTAL
6.1 gal., 39 min.
(on some
This cycle is for lightly soiled china and crystal.
models)
RINSE ONLY
1.2 gal., 6 min.
For rinsing partial loads that will be washed later. Do not use detergent with this cycle.
NOTE:
Only the
SANI-WASH
cycle has been designed to meet the requirements of Section 6, NSF 184 for
soil removal and sanitization efficacy
.
1
1
3
4
2
2