Hotpoint RB526HWW Use and Care Manual / Warranty - Page 33
Safety Instructions, Operating Instructions, Care and Cleaning, Consumer Support
View all Hotpoint RB526HWW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
Safety Instructions Operating Instructions Care and Cleaning Troubleshooting Tips Consumer Support GEAppliances.com Problem Excessive condensation in the warming drawer Food dries out in the warming drawer Oven temperature too hot or too cold Clock and timer do not work Display goes blank Oven door is crooked Possible Causes Liquid in warming drawer. Uncovered foods. Temperature setting too high. Moisture escaping. Oven thermostat needs adjustment. Plug on range is not completely inserted in the electrical outlet. A fuse in your home may be blown or the circuit breaker tripped. Oven controls improperly set. A fuse in your home may be blown or the circuit breaker tripped. The clock is turned off from showing in the display. The door is out of position. Oven makes clicking noise "F-and a number or letter" flash in the display This is the sound of the heating element turning off and on during cooking functions. you have a function error code. If the function code repeats: Power outage Power outage or surge. Display flashes Power failure. Unable to get the display Oven control pads were not to show "SF" pressed properly. What To Do • Remove liquid. • Cover food with lid or aluminum foil. • Reduce temperature setting. • Cover food with lid or aluminum foil. • See the Adjust the oven thermostat-Easy to do yourself! section. • Make sure electrical plug is plugged into a live, properly grounded outlet. • Replace fuse or reset circuit breaker. • See the using the clock and timer section. • Replace the fuse or reset the circuit breaker. • See the using the clock and timer section. • Because the oven door is removable, it sometimes gets out of position during installation. To straighten the door, push down on the high corner. • This is normal. • Press the CLEAR/OFF pad. Put the oven back into operation. • Disconnect all power to the range for at least 30 seconds and then reconnect power. If the function error code repeats, call for service. • On self-cleaning models, if a function error code appears during the self-cleaning cycle, check the oven door latch. The latch may have been moved, if only slightly, from the locked position. Make sure the latch is moved to the right as far as it will go. Press the CLEAR/OFF pad. Allow the oven to cool for one hour. Put the oven back into operation. • Some models will automatically resume their setting once the power is restored. On models with a clock, you must reset the clock. If the oven was in use, you must reset it by pressing the CLEAR/OFF pad, setting the clock and resetting any cooking function. • Reset the clock. • The BAKE and BROIL HI/LO pads must be pressed at the same time and held for 3 seconds.