Hotpoint RB757WHWW Use and Care Manual / Warranty - Page 26

CAUTION, Care and cleaning of the range.

Page 26 highlights

Consumer Support Troubleshooting Tips Care and Cleaning Operating Instructions Safety Instructions Care and cleaning of the range. Oven Heating Elements Do not clean the bake element or the broil element. Any soil will burn off when the elements are heated. To clean the oven floor, gently lift the bake element. Clean with warm soapy water. On some models, the bake element is not exposed and is under the oven floor. If spillovers, residue or ash accumulate on the oven floor, wipe up before self-cleaning. Wire cover holder Oven Racks Clean the oven racks with an abrasive cleanser or scouring pad. After cleaning, rinse the racks with clean water and dry with a clean cloth. NOTE: Take the racks out of the oven before you begin the self-clean cycle or they may discolor. To make the racks slide more easily, apply a small amount of vegetable oil or cooking oil to a paper towel and wipe the edges of the oven racks with the paper towel. Oven Light Replacement (on some models) CAUTION: Before replacing your oven light bulb, turn the oven light off and disconnect the electrical power to the range at the main fuse or circuit breaker panel. Be sure to let the light cover and bulb cool completely. To replace the cover: Place it into groove of the light receptacle. Pull wire forward to the center of the cover until it snaps into place. Connect electrical power to the range. To remove the cover: Hold a hand under the cover so it doesn't fall when released. With fingers of the same hand, firmly push back the wire cover holder. Lift off the cover. Do not remove any screws to remove the cover. Replace bulb with a 40-watt household appliance bulb. Clean under the range. Storage Drawer Removal (on some models) To remove the storage drawer: Pull the drawer out all the way. To replace the storage drawer: Insert glides at the back of the drawer beyond the stop on range glides. Tilt up the front and remove it. Lift the drawer if necessary to insert easily. Let the front of the drawer down, then push in to close. 26

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40

CAUTION:
Before replacing
your oven light bulb, turn the oven light off
and disconnect the electrical power to the
range at the main fuse or circuit breaker
panel.
Be sure to let the light cover and bulb cool
completely.
To remove the cover:
Hold a hand under the cover so it doesn’t
fall when released. With fingers of the
same hand, firmly push back the wire
cover holder. Lift off the cover.
Do not remove any screws to remove
the cover.
Replace bulb with a 40-watt household
appliance bulb.
To replace the cover:
Place it into groove of the light
receptacle. Pull wire forward to the
center of the cover until it snaps
into place.
Connect electrical power to the range.
Do not clean the bake element or the broil
element. Any soil will burn off when the
elements are heated.
To clean the oven floor, gently lift the bake
element. Clean with warm soapy water.
On some models, the bake element is not
exposed and is under the oven floor. If
spillovers, residue or ash accumulate on the
oven floor, wipe up before self-cleaning.
Clean the oven racks with an abrasive
cleanser or scouring pad. After cleaning,
rinse the racks with clean water and dry with
a clean cloth.
NOTE:
Take the racks out of the oven before
you begin the self-clean cycle or they may
discolor.
To make the racks slide more easily, apply a
small amount of vegetable oil or cooking oil
to a paper towel and wipe the edges of the
oven racks with the paper towel.
Wire cover holder
Oven Heating Elements
Oven Racks
Oven Light Replacement
(on some models)
Care and cleaning of the range.
26
Consumer Support
Troubleshooting Tips
Care and Cleaning
Operating Instructions
Safety Instructions
To remove the storage drawer:
Pull the drawer out all the way.
Tilt up the front and remove it.
To replace the storage drawer:
Insert glides at the back of the drawer
beyond the stop on range glides.
Lift the drawer if necessary to insert
easily.
Let the front of the drawer down, then
push in to close.
Clean under the range.
Storage Drawer Removal
(on some models)