Hunter 20345 Owner's Manual - Page 8
For Standard or Angled mounting, For Low Profile mounting
View all Hunter 20345 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
3 • Assembling the Fan Standard or Angle Mounting Steps 3-2 - 3-3 Downrod Set Screw Canopy Canopy Trim Ring WARNING: Fan may fall if not assembled as directed in these installation instructions. 3-1. Unbundle the wires from the fan. For Standard or Angled mounting: 3-2. Insert the downrod through the canopy and canopy trim ring. Feed the wires from the fan through the downrod on one side of the pin in the ball. 3-3. Loosen the square head set screw on the adapter to install the pipe and ball assembly. Note: When the pipe and ball assembly is fully installed, 2-3 threads on the pipe will still be visible; this is normal. Securely retighten the set screw with a wrench or pliers. CAUTION: The adapter has a special coating on the threads. Do not remove this coating; the coating prevents the downrod from unscrewing. Once assembled, do not remove the downrod. For Low Profile mounting: Low Profile Mounting Steps 3-5 - 3-6 Locking Screws Note: For low profile mounting, the downrod is replaced with the low profile washer. 3-4. Remove the set screw from the adapter. 3-5. Place the low profile washer into the canopy with the lip down. Green Ground Wire Low Profile 3-6. Align the holes in the washer with the holes in the adapter. Washer Assemble securely with three locking screws. Canopy Trim Ring Canopy Step 3-6 (Detail) Adapter Locking Screws Locking Screw Low Profile Washer 8 42616-01 • 02/02/10 • Hunter Fan Company