Hunter 20531 Owner's Manual - Page 8

3 • Assembling and Hanging the Fan You can assemble your fan for standard mounting (steps 3-1 - 3-2) or for low profile mounting (steps 3-3 - 3-4). 3-1. To assemble fan to hang down from a flat or angled ceiling, insert the downrod through the canopy. Feed the wires from the fan through the downrod. 3-2. Loosen the setscrew on the adapter to install the pipe and ball assembly. Note: When the pipe and ball assembly is fully installed, 2-3 threads on the pipe will still be visible; this is normal. Securely retighten the setscrew with a wrench or pliers. Skip to Step 3-5. CAUTION: The adapter has a special coating on the threads. Do not remove this coating; the coating prevents the downrod from unscrewing. Once assembled, do not remove the downrod. 3-3. Place the low profile washer into the canopy. Be sure the green ground wire is pointing up toward the ceiling. Note: For low profile mounting, the downrod is replaced with the low profile washer. See Steps 3-3 - 3-4. 3-4. Align the holes in the washer with the holes in the adapter. Assemble securely with three #8-32 x 1" screws. 3-5. Raise the fan and align the slots in the canopy with the tabs on the ceiling plate. Go to 4 • Wiring the Fan. WARNING: Fan may fall if not assembled as directed in these installation instructions. Steps 3-1 - 3-2 Setscrew Steps 3-3 - 3-4 Ceiling Plate Tabs Step 3-5 Downrod Canopy Low Profile Washer #8-32 x 1" Screw Canopy Slots 8 42450-01 • 11/18/10 • Hunter Fan Company