Hunter 20775 Owner's Manual - Page 7
standard, angled, low profile, For Low Profile Mounting
View all Hunter 20775 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
3 • Assembling and Hanging the Fan (Low Profile Only) WARNING: Fan may fall if not assembled as directed in these installation instructions. Step 3-6 You can assemble your fan for standard or angled mounting as shown in steps 3-1 - 3-4 on the previous page. For low profile mounting (ceilings less than 8 feet high), see steps 3-5 - 3-11 on this page. For Low Profile Mounting: Note: For low profile mounting, the downrod is replaced with the low profile washer. 3-5. Unbundle the wires from the fan. 3-6. Remove the screw from the hanger ball on the downrod, and then remove the hook from the hanger ball. Step 3-8 CAUTION: The adapter has a special coating on the threads. Do not remove this coating; the coating prevents the downrod from unscrewing. Once assembled, do not remove the downrod. 3-7. Remove the setscrew from the adapter. 3-8. Install the hook and two neoprene washers onto the adapter using the setscrew. the top of the hook must hang over the adapter. Note: The screw should be tight, but still allow the hook to rotate slightly. 3-9. Place the low profile washer (lip up) into the canopy. Be sure the Steps 3-9 - 3-10 green ground wire is pointing up toward the ceiling. 3-10. Align the holes in the washer with the holes in the adapter. Assemble securely with three low profile screws. 3-11. Raise the fan and place the hook on the adapter through the loop on the ceiling plate. Low Profile Washer Loop Step 3-11 Low Profile Screw 7 42508-01 • 09/23/08 • Hunter Fan Company