Hunter 21564 Owner's Manual - Page 5
Hunter Fan Company
View all Hunter 21564 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
2 • Installing the Hanger Bracket CAUTION: To avoid possible electrical shock, before installing your fan, disconnect the power by turning off the circuit breakers to the outlet box and associated wall switch location. If you cannot lock the circuit breakers in the off position, securely fasten a prominent warning device, such as a tag, to the service panel. 2-1. Drill two pilot holes into the wood support structure through the outermost holes in the outlet box. The pilot holes should be 9/64" in diameter. 2-2. Thread the lead wires from the outlet box down through the hole in the middle of the ceiling plate. 2-3. Align the slotted holes in the ceiling plate with the pilot holes you drilled in the wood support structure. 2-4. Place a flat washer on each of the two 3" wood screws and pass the screws through the slotted holes in the ceiling plate into the pilot holes you drilled. Tighten the screws into the 9/64" pilot holes; do not use lubricants on the screws. Do not over tighten. Ceiling Plate Steps 2-4 - 2-6 Flat Washer 3" Wood Screw 5 42890-01 • 02/18/10 • Hunter Fan Company