Hunter 21647 Owner's Manual - Page 8
For Standard or Angled mounting, For Low Profile mounting
View all Hunter 21647 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
3 • Assembling and Hanging the Fan WARNING: Fan may fall if not assembled as directed in these installation instructions. 3-1. Unbundle the wires from the fan. For Standard or Angled mounting: 3-2. To assemble fan to hang down from a flat or angled ceiling, insert the downrod through the canopy and canopy trim ring. Feed the wires from the fan through the downrod. 3-3. Loosen the square head setscrew on the adapter to install the pipe and ball assembly. Note: When the pipe and ball assembly is fully installed, 2-3 threads on the pipe will still be visible; this is normal. Securely retighten the setscrew with a wrench or pliers. Skip to Step 3-7. CAUTION: The adapter has a special coating on the threads. Do not remove this coating; the coating prevents the downrod from unscrewing. Once assembled, do not remove the downrod. For Low Profile mounting: Note: For low profile mounting, the downrod is replaced with the low profile washer. 3-4. Remove the setscrew from the adapter. 3-5. Place the low profile washer (lip up) into the canopy. Be sure the green ground wire is pointing up toward the ceiling. 3-6. Align the holes in the washer with the holes in the adapter. Assemble securely with three low profile screws. 3-7. Raise the fan and place the hook on the ceiling plate through the U-shaped hole in the rim. Step 3-7 U-shaped Hole Steps 3-2 - 3-3 Downrod Canopy Canopy Trim Ring Setscrew Steps 3-5 - 3-6 Low Profile Washer Low Profile Screw 8 41847-01 • 05/28/10 • Hunter Fan Company