Hunter 21978 Owner's Manual - Page 9

4 • Assembling and Hanging the Fan WARNING: Fan may fall if not assembled as directed in these installation instructions. 4-1. Unbundle the wires from the fan. For Standard or Angled mounting: 4-2. To assemble fan to hang down from a flat or angled ceiling, insert the downrod through the canopy. Feed the wires from the fan through the downrod. 4-3. Loosen the square head setscrew on the adapter to install the downrod. Note: When the downrod is fully installed, 2-3 threads on the pipe will still be visible; this is normal. Securely retighten the setscrew with a wrench or pliers. Skip to Step 5-7. CAUTION: The adapter has a special coating on the threads. Do not remove this coating; the coating prevents the downrod from unscrewing. Once assembled, do not remove the downrod. For Low Profile mounting: Note: For low profile mounting, the downrod is replaced with the low profile washer. 4-4. Remove the setscrew from the adapter. 4-5. Place the low profile washer (lip down) into the canopy. Be sure the green ground wire is pointing up toward the ceiling. 4-6. Align the holes in the washer with the holes in the adapter. Assemble securely with three low profile screws. 4-7. Raise the fan and place the hook on the ceiling plate through the round hole in the rim. Steps 4-1 - 4-2 Setscrew Downrod Canopy Steps 4-4 - 4-5 Low Profile Washer Step 4-6 Low Profile Screw Round Hole 9 41225-01 • 12/04/09 • Hunter Fan Company