Hunter 28079 Owner's Manual - Page 6
For Standard or Angle mounting, For Low Profile mounting, Hanging the Fan
View all Hunter 28079 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
3 • Assembling and Hanging the Fan Standard or Angle Mounting Steps 3-2 - 3-3 WARNING: Fan may fall if not assembled as directed in these installation instructions. Downrod 3-1. Unbundle the wires from the fan. For Standard or Angle mounting: Set Screw Canopy Canopy Trim Ring Low Profile Mounting Steps 3-5 - 3-6 Low Profile Screws 3-2. Insert the downrod through the canopy and canopy trim ring. Feed the wires from the fan through the downrod on one side of the pin in the ball. 3-3. Loosen the square head set screw on the adapter to install the pipe and ball assembly. Note: When the pipe and ball assembly is fully installed, 2-3 threads on the pipe will still be visible; this is normal. Securely retighten the set screw with a wrench or pliers. Skip to step 3-7. CAUTION: The adapter has a special coating on the threads. Do not remove this coating; the coating prevents the downrod from Green Ground Wire Canopy Trim Ring Low Profile Washer Canopy unscrewing. Once assembled, do not remove the downrod. For Low Profile mounting: Note: For low profile mounting, the downrod is replaced with the low profile washer. 3-4. Remove the set screw from the adapter. 3-5. Place the low profile washer into the canopy with the lip down. Low Profile Screw 3-6. Align the holes in the washer with the holes in the adapter. Assemble securely with three low profile screws. Step 3-6 (Detail) Adapter Low Profile Screw Low Profile Washer Hanging the Fan: Note: To hang the fan, you must tilt the canopy to an almost vertical position so that the canopy slots sit on the ceiling plate hooks. 3-7. Raise the fan and align the slots in the canopy with the hooks on the ceiling plate. 3-8. Place the slots over the hooks to hang the fan.