Husqvarna 125BVx Owners Manual - Page 13

USING THE BLOWER To blow away debris on the ground Fitting the blower tube and nozzle on the blower WARNING: When fitting the blow- er tube and nozzle, the engine must be switched off. The blower tube (T) has a pegged slot mounting system to the unit. To install or remove the blower tube (or collection bag tube for the 125BVX--SERIES), loosen the tube clamp bolt (do not remove nuts from bolt). Align slot in the blower air outlet with the raised rib on the tube and insert tube. Tighten tube clamp bolt. 125BVX--SERIES can be used with a shoulder strap for extra comfort. The strap U should be worn over the shoulder as shown. T The nozzles (U) have a bayonet mount for connection to the blower tube. Air is channeled through the blower tube to the nozzles, where the air discharge velocity increases and the air stream discharge pattern is formed to provide best performance. The length of the blower tube can be adjusted by twisting the nozzle to the left to disengage the bayonet mount and sliding the nozzle to the appropriate position. Twist the nozzle to the right until a click is felt to re--secure the nozzle. Blowing Before you begin blowing, put on the required safety equipment. WARNING: When working with the blower, wear the required personal safety equipment: 1. Hearing protection. 2. Eye protection. 3. Protective gloves. 4. Face mask in dusty environments. 115277126 Rev. 2 5/1/10 WARNING: Never point the blower nozzle at people or animals. The high- velocity air stream can contain particles that may cause serious injury, especially if the blower has previously been used for vacuuming. Be careful, particularly if left hand operation is applied. Avoid any direct body contact with inlet cover area. Keep jewelry, loose clothing, or clothing with loosely hanging straps, ties, tassels, etc., away from inlet cover area. English--- 13