Husqvarna 128L Owners Manual
Husqvarna 128L Manual
 |
View all Husqvarna 128L manuals
Add to My Manuals
Save this manual to your list of manuals |
Husqvarna 128L manual content summary:
- Husqvarna 128L | Owners Manual - Page 1
SERVICE 545196750 OM, 128L/C , 2009-02, 545196750 128 L, 128 C 545 19 67-50 - Husqvarna 128L | Owners Manual - Page 2
16 Muffler 17 Spark plug 17 Air filter 18 Bevel gear 18 Maintenance schedule 18 Trimmer head line loading instructions . . 19 TECHNICAL DATA Technical data 21 WARRANTY STATEMENT 22 EMISSION CONTROL WARRANTY STATEMENT 23 Note the following before starting: Husqvarna AB has a policy - Husqvarna 128L | Owners Manual - Page 3
manual carefully and make sure you understand the instructions before using the machine. Always wear: S Hearing protection S Approved eye protection Max. speed of output shaft use non--metallic, flexible cutting attachments, i.e. trimmer heads with trimmer line. 545196750 Rev. 3 2/17/09 English--- - Husqvarna 128L | Owners Manual - Page 4
SAFETY INSTRUCTIONS Personal protective equipment IMPORTANT! Whenever you use a clearing saw, brushcutter or trimmer you must wear personal Always remove your hearing protection as soon as the engine stops. GLOVES Gloves should be worn when necessary, e.g., when fitting cutting attachments. - Husqvarna 128L | Owners Manual - Page 5
serious personal injury. Use of incorrectly wound trimmer line or an incorrect cutting attachment increases the level of vibration. WARNING: may contain sparks which can start a fire. Never start the machine indoors or near combustible material! Cutting equipment A trimmer head is intended - Husqvarna 128L | Owners Manual - Page 6
if it has been exposed to impact or is cracked. S Always use the recommended guard for the cutting attachment you are using. See section on "Technical data". Muffler S See instructions under the section "Start". Start the machine and apply full throttle. Release the throttle and check that the - Husqvarna 128L | Owners Manual - Page 7
trimmer line and the correct line diameter. WARNING: Always stop the en- gine before doing any work on the cutting attachment. This continues to rotate even after the throttle has been released. Ensure that the cutting attachment has stopped completely and disconnect the lead from the spark plug - Husqvarna 128L | Owners Manual - Page 8
understood the contents of the operator's manual. Safety instructions before starting work S Inspect the working area. Remove any objects such as stones, broken glass, nails, steel wire, string, etc. that can be thrown or can wrap around the cutting head or shaft. S Keep others at a safe distance - Husqvarna 128L | Owners Manual - Page 9
that has parts missing or has been changed in relation to the specification. S Only use the machine for the purpose for which it was intended. Starting WARNING: When the engine is started with the choke in either the choke or start throttle positions the cutting attachment will start to rotate - Husqvarna 128L | Owners Manual - Page 10
Never press the trimmer line into the area to be cut. S Do not allow the trimmer head to con-stantly come into contact with the ground during normal cutting. Constant contact of this type can cause damage and wear to the trimmer head. S The trimmer line can easily remove grass and weeds up against - Husqvarna 128L | Owners Manual - Page 11
remove the cut material while the engine is running or the trimmer line is rotating, as this can result in serious injury. Stop the engine and trimmer head before you remove material that has wound around the drive shaft protection. Never lean over the cutting attachment guard. Stones, rubbish, etc. - Husqvarna 128L | Owners Manual - Page 12
4 1 KNOW YOUR TRIMMER 6 128L 5 16 128C 8 10 9 11 7 15 13 14 12 4 1 17 18 Know your trimmer 1. Trimmer head 11. Starter handle 2. Grease filler cap 12. Fuel tank 3. Bevel gear 13. Choke control 4. Cutting attachment guard 14. Primer bulb 19 5. Shaft 15. Air filter cover 6. Loop - Husqvarna 128L | Owners Manual - Page 13
as shown in this manual. trimmer head (Model 128C) Fitting the loop handle S Position the handle on the shaft. Note that the handle must be mounted be- tween the two arrows on the shaft. S Fit the correct trimmer guard (A) for use with the trimmer head. Hook the trimmer guard/combination guard - Husqvarna 128L | Owners Manual - Page 14
use HUSQVARNA two--stroke oil, which is specially formulated for our two--stroke engines. Mixture 1:50 (2%). S To maximize the life of your trimmer, area before starting. Min. 10 ft. (3 m) S Clean the area around the fuel cap. Contamination in the tank can cause operating problems. S Ensure - Husqvarna 128L | Owners Manual - Page 15
clutch, clutch cover, and shaft must be fitted before the machine is started, otherwise parts could come loose and cause personal injury. Always move the machine away from the refueling area before starting. Place the machine on a flat surface. Ensure the cutting attachment cannot come into contact - Husqvarna 128L | Owners Manual - Page 16
the cutting attachment will start to rotate immediately. MAINTENANCE The owner is responsible for the performance of all required maintenance as defined in the operator's manual. WARNING: Improper mainte- nance could result in serious engine damage or in serious injury. Carburetor Your Husqvarna - Husqvarna 128L | Owners Manual - Page 17
fuel mixture (too much or in- correct type of oil). S A dirty air filter. These factors cause deposits on the spark plug electrodes, which may result in operating problems and starting difficulties. If the machine is low on power, difficult to start or runs poorly at idle speed: always check the - Husqvarna 128L | Owners Manual - Page 18
find some general mainte- nance instructions. The air filter must be regularly cleaned to remove dust and dirt in order to avoid: S Carburetor malfunctions S Starting problems S Loss of engine power S Unnecessary wear to engine parts S Excessive fuel consumption Clean the filter every 25 hours, or - Husqvarna 128L | Owners Manual - Page 19
Trimmer Head Line Loading Instructions 1 2 3 4 5 6m 20i 3m 10i 6 7 8 9 545196750 Rev. 3 2/17/09 English--- 19 - Husqvarna 128L | Owners Manual - Page 20
Plastic Blades (Tri Cut) 1 2 3 4 5 6 7 8 545196750 Rev. 3 2/17/09 English--- 20 - Husqvarna 128L | Owners Manual - Page 21
128C (3/8 RH arbor shaft thread) Approved accessories Type Trimmer head T25 Cutting attachment / guard, part. no. 537 33 83--07 / 545 03 11--01 Model 128L (M10 LH arbor shaft thread) Approved accessories Type Trimmer head T25 Plastic blades Tricut 300 mm Cutting attachment / guard, part - Husqvarna 128L | Owners Manual - Page 22
use, including, but not limited to, filters, lubricants, rewind springs, spark plugs, and starter ropes. (2) Natural discoloration of in accordance with the operator's manual or instruction sheet furnished by Husqvarna. (3) Alterations or modifications that change the intended use of the product - Husqvarna 128L | Owners Manual - Page 23
U.S. Environmental Protection Agency, California Air Resources Board, Environment Canada and HUSQVARNA are pleased to explain the emissions OR REPLACEMENT OF PARTS. Repair or replacement of any warranted part will be performed at no charge to the owner at an approved HUSQVARNA servicing center. If - Husqvarna 128L | Owners Manual - Page 24
maintenance or repair on emission related parts will be provided without charge to the owner if the part is under warranty. EMISSION CONTROL WARRANTY PARTS LIST: Carburetor, Air Filter (covered up to maintenance schedule), Ignition System: Spark Plug (covered up to maintenance schedule), Ignition
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
-
17
-
18
-
19
-
20
-
21
-
22
-
23
-
24
 |
 |
SERVICE
545
196750
OM
,
128L
/C
,
2009-0
2
,
545
196750
128 L
, 128 C
545 19
67
-
50