Husqvarna 128L Owners Manual - Page 6
Throttle lock--out, Stop switch, Cutting attachment guard, Muffler, Rev. 3
View all Husqvarna 128L manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
SAFETY INSTRUCTIONS Throttle lock--out S Make sure the throttle control is locked at the idle setting when the throttle lock-out is released. Stop switch S Start the engine and make sure the engine stops when you push and hold the stop switch. S Press the throttle lock--out and make sure it returns to its original position when you release it. Cutting attachment guard S Ensure that the guard is undamaged and is not cracked. S Check that the throttle control and throttle lock--out move freely and that the return springs work properly. S Replace the guard if it has been exposed to impact or is cracked. S Always use the recommended guard for the cutting attachment you are using. See section on "Technical data". Muffler S See instructions under the section "Start". Start the machine and apply full throttle. Release the throttle and check that the cutting attachment stops and remains at a standstill. If the cutting attachment rotates with the throttle in the idle position then the carburetor idle setting must be checked. See instructions under the section "Maintenance". S Never use a machine that has a faulty muffler. S Regularly check that the muffler is securely attached to the machine. 545196750 Rev. 3 2/17/09 S The muffler on this unit is equipped with a special spark arrestor mesh. The mesh should be checked and, if necessary. cleaned by a servicing dealer. A blocked mesh will cause the machine to overheat, which can lead to serious damage. Never use a muffler with a defective spark arrestor mesh. See the Maintenance section. English--- 6