Husqvarna 223R Owners Manual - Page 11
Assembly - diagrams
View all Husqvarna 223R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
ASSEMBLY Fitting the handlebar • Remove the screw at the rear of the throttle handle. • Slide the throttle handle onto the right side of the handlebar, (see diagram). Fitting blades and trimmer heads WARNING! ! When fitting the cutting attachment it is extremely important that the raised section on the drive disc/support flange engages correctly in the centre hole of the cutting attachment. If the cutting attachment is fitted incorrectly it can result in serious and/or fatal personal injury. • Align the screw hole in the throttle handle with the hole in the handlebar. • Refit the screw in the hole in the rear of the throttle handle. • Screw the screw through the handle and handlebar. Tighten it. • Fit the mounting components as shown. WARNING! Never use a cutting attachment ! without an approved guard. See the chapter on Technical data. If an incorrect or faulty guard is fitted this can cause serious personal injury. IMPORTANT! If a saw blade or grass blade are to be used the machine must be equipped with the correct handlebar, blade guard and harness. • The handle mounting must be fitted between the arrows on the shaft. • Loosely tighten the four screws. • Put on the harness and hang the machine from the support hook. Now make a final adjustment so that the machine is in a comfortable working position when it hangs from the harness. Tighten the screws. English - 11