Husqvarna 390 XP G Owners Manual - Page 39

TECHNICAL DATA Recommended original and replacement bar and chain combinations These Husqvarna chain saw models are in the ANSI category of saws above 3,8 cu. in. and are not required to comply with low kickback performance requirements. However, for these models we recommend the following cutting equipment. Bar Length, inch 18-28 Pitch, inch 3/8" 18-28 3/8" Gauge, inch 0,058 0,058 Max. nose radius 11T ATM 1,33" Chain Type Husqvarna H42, Oregon 73LP / 73LG / 73V Drive link count 68-92 68-92 Listed ATM is the Oregon designation of Armour Tip Medium hard nose bar. Note: For the chains above you are free to choose between 0,050" and 0,058" gauge drive link for the corresponding bar, see the table below. 0,050"/1,3 mm 0,058"/1,5 mm - 72LP 72LG 72V H42 73LP 73LG 73V WARNING! This chain saw model is capable of severe kickback that could result in serious injuries ! to the user. Do not operate this saw unless you have extraordinary cutting needs and experience and specialized training for dealing with kickback. Saws with significantly reduced kickback potential are available. Always use the safest saw and cutting equipment applicable to your cutting need. Saw chain filing and file gauges English - 39