Husqvarna HU675AWD Owners Manual - Page 5
To Assemble Grass Catcher, See Fig. 3, To Install Attachments, Install Starter Rope See Fig. 4 - side discharge
View all Husqvarna HU675AWD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
ASSEMBLY TO ASSEMBLE GRASS CATCHER (See Fig. 3) 1. Put grass catcher frame into grass bag with rigid part of bag on the bottom. Make sure the frame handle is outside of the bag top. 2. Slip vinyl bindings over frame. NOTE: If vinyl bindings are too stiff, hold them in warm water for a few minutes. If bag gets wet, let it dry before using. INSTALL STARTER ROPE (See Fig. 4) 1. Loosen T-knob. 2. Hold control bar against upper handle. 3. Slowly pull engine starter rope out until rope will slip into loop of rope guide. 4. Tighten T-knob. FRAME HANDLE VINYL BINDINGS FIG. 3 FRAME OPENING CONTROL BAR UPPER HANDLE ROPE GUIDE T-KNOB ENGINE STARTER ROPE FIG. 4 TO INSTALL ATTACHMENTS Your lawn mower was shipped ready to be used as a mulcher. To convert mower to bagging or discharging, see "TO CONVERT MOWER" in the Operation section of this manual. 5