IBM 2681 Setup Guide - Page 7
Attention, then press - memory
 |
UPC - 087944884422
View all IBM 2681 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
If the SO-DIMM is already in the memory slot, remove it to make room for the new one by pressing out on the latches on both edges of the socket at the same time. Be sure to save it for future use. 5. Find the notch on the side of the SO-DIMM. Attention: To avoid damaging the SO-DIMM, do not touch its contact edge. 6. With the notched end of the SO-DIMM toward the right side of the socket, insert the SO-DIMM into the socket at an angle of about 20 degrees 1 ; then press it firmly 2 . 2 1 2 1 20 7. Pivot the SO-DIMM until it snaps into place. Make sure that the card is firmly fixed in the slot and does not move easily. 7
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8 -
9
 |
 |
If the SO-DIMM is already in the memory slot, remove it to make room for the
new one by pressing out on the latches on both edges of the socket at the same
time. Be sure to save it for future use.
5.
Find the notch on the side of the SO-DIMM.
Attention:
To avoid damaging the SO-DIMM, do not touch its contact edge.
6.
With the notched end of the SO-DIMM toward the right side of the socket, insert
the SO-DIMM into the socket at an angle of about 20 degrees
±1²
; then press it
firmly
±2²
.
2
2
1
1
20
7.
Pivot the SO-DIMM until it snaps into place.
Make sure that the card is firmly fixed in the slot and does not move easily.
7