IBM 4840-544 Service Guide - Page 132
Removing, replacing, full-size, slide, assembly
View all IBM 4840-544 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 132 highlights
Cash drawer FRUs August 3, 2006 Rail Button (one on each side) Drawer Guide Figure 81. Removing and replacing a full size cash drawer To replace a cash drawer: 1. Make sure that the latch assembly is unlatched; otherwise, the drawer will not close properly. 2. Pull both slides all the way out. 3. Position the rear of the drawer into the slides so that the drawer guide on each side of the drawer aligns with the corresponding opening on each side, as shown in Figure 81. 4. Pivot the front of the drawer downward until it is positioned fully into the slides. 5. Close the drawer to make sure it closes correctly and remains closed. Removing and replacing a full-size slide assembly To remove a cash-drawer slide assembly: 1. Disconnect the cash drawer cable. 2. Remove the drawer as described at "Removing and replacing a full-size drawer" on page 105). 3. Remove the latch assembly (see "Removing and replacing the latch and sensor assembly" on page 114). 4. Remove the three screws that secure the slide to the base and lift out the slide assembly, as shown in Figure 82 on page 107. 5. If necessary, remove the top cover from the base (see "Removing and replacing the top cover" on page 113). 106