Icom IC-GM1600 Instruction Manual - Page 29
Troubleshooting
View all Icom IC-GM1600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
11 TROUBLESHOOTING PROBLEM POSSIBLE CAUSE SOLUTION REF. The transceiver does • The battery is exhausted. not turn ON. • Bad connection to the battery pack. • Change to a new battery pack (Survival). • Recharge the battery pack (On-board). • Check the connection to the transceiver. p. 16 pgs. 17-20 p. 3 No sound from the • Squelch level is too deep. • Set squelch to the threshold point. p. 9 speaker. • Volume level is too low. • Rotate [VOL] to set a suitable level. p. 8 • Speaker has been exposed to water. • Drain water from the speaker. - • Water has entered the [MIC/SP] connector. • Dry [MIC/SP] connector. - Transmitting is impos- • Some channels are for low power or re- • Change channels. pgs. 8, sible, or high power ceive only. 23 can not be selected. • The battery is exhausted. • Change to a new battery pack (Survival). p. 16 • Recharge the battery pack (On-board). pgs. 17-20 • The output power is set to low. • Push [Hi/Lo• ] to select high power. p. 8 10 The displayed channel • Lock function is activated. cannot be changed. • Push [Hi/Lo• ] for 1 sec. to cancel the p. 10 function. 11 No beeps. • Beep tones are turned OFF. • Set the beep tones to ON (Fix Beep/User p. 12 Beep) on the SET mode. Self check error. (Temperature) • The temperature is outside of -35°C to • Leave the transceiver at room temperature - +80°C; -31°F to +173°F (approx.). for a while. Turn the power ON to check if the internal temperature has returned to normal. Self check error. • The connected battery pack's voltage is • Verify the battery voltage is correct. - (Battery voltage) more than 11 V. Transmitting continu- • Ambient noise is too loud. ously while not speaking when using VOX function. • Remove the headset cable. • Reduce the VOX gain setting. p. 14 24