Image Fitness Renew 639 English Manual - Page 9

3. Insert the pillow (47) into the lounge seat recepta- 3 cle. Rotate the pillow 180º to change its position. 47 4. The hydrotherapy spa operates on a 240-volt power source and must be wired directly to a 40 amp ground fault circuit interrupter (GFCI) installed in your home. This procedure must be performed by a qualified electrician. A wiring diagram is found on the inside of the electronics pack as a reference. Under no circumstances should the spa be wired by someone other than a qualified electrician. Before you have the spa wired, make sure that it is in the position you want and that it can be easily serviced, if needed. 5. Make sure that a qualified electrician has wired the 5 spa to a 240-volt power source. Remove the two warning decals (see page 5) from the spa shell. Using a damp cloth, wipe the spa shell clean. Before filling the spa, make sure that it is in the desired position and that there is room to easily service it. Once the spa is filled, it will have to be drained before it can be moved. Insert a garden hose into the filter housing and fill the spa. Do not use soft water. The spa may be filled with cold water; however, if warm or hot water is used, the spa will be ready for use sooner. Fill the spa until the water is at the middle of the skimmer (see O on page 11). Do not overfill the spa. Refer to the inset drawing. Set the Filter (5), Cartridge Plug (16), Diverter (21), and Basket (22) into the filter housing. Next, screw the Filter Cover (3) into the filter housing until it is fully seated. 3 22 21 16 5 Garden Hose Filter Housing 6. Pull down one of the straps on the Spa Cover (11) and hold the Buckle (26) against one of the premium 6 cedar panels on the spa. (Note: To position the 11 Buckle correctly, have a second person hold the strap on the opposite side of the Spa Cover snug.) The Spa Cover must be snug. Do not place the Buckle over the grooves between the premium cedar panels. Refer to the inset drawing. Remove the latch from the Buckle (26). Attach the Buckle to the premium cedar panel with two #4 x 3/4" Screws (27). Attach the other three Buckles (26) to the premium cedar panels in the same way. Remove the Spa Cover (11) from the spa. Strap Latch 26 27 Strap 26 9