InSinkErator Model CWT-00 Owners Manual - Page 3

These instructions assume instant hot/cool water dispenser faucet, tank and/or filter has already been installed. Refer to Installation, Care & Use manual included with hot/cool water dispenser. Cold Only Faucet Follow these steps for installing chilled water tank with instant hot/cool water dispenser. 1 aPreparation Blue Tubing Copper Tubing Filter White Tubing < 18" < 11" < 15" Chilled Water PropeTratnykDamage: Do not place objects on top of chilled water tank which could obstruct the fan. U nplug instant hot water tank and hold handle in open position until cool water flows from spout. T urn off water supply. Food Waste Identify the undersink locatioDnisfpoorstehr e chilled water tank. F or best performance, allow for a minimum 2" space around the sides and top of the chilled water tank. T he chilled water tank will require a minimum footprint by 11" deep. of 15" widASeiirn-kATcotpivaStweditch™ E nsure that there is a minimum of 18" vertical clearance for the chilled water tank. OVERVIEW OF A TYPICAL INSTALLATION with Instant Hot Water Dispenser Shown with optional filtration Follow these steps for installing chilled water tank with instant hot/cool water dispenser. 2 Installing the water tank a A ttach supplied quick connect elbow to end of supplied white 1/4" tube. Inlet A ttach quick connect elbow to water Inlet on front of chilled water tank. Property Damage: All tubesInmletust be cut squarely with no bOuutlretrs. M easure distance from water inlet on chilled water tank to water supply valve. Carefully trim white 1/4" tube, allowing ample slack in tubing. b White Tape Outlet Property Damage: Do not pinch or break tubing. Do not distort the last 1" of tubing. Pull on connection to ensure fully engaged. A ttach supplied quick connect elbow to end of supplied blue 1/4" tube. A ttach quick connect elbow with blue tube to water Outlet on front of chilled water tank. M easure distance from the chilled water tank outlet to water supply line on faucet. Carefully trim blue tube to correct length. U sing quick connect elbow, connect remaining end of blue tube to unmarked copper tube coming from faucet. Filter Instant Hot Water Tank Instant Hot/Cool Water Dispenser Faucet Copper Tubing White Tape Air-Activated SinkTop Switch™ White Tape Blue Tubing Food Waste Disposer White Tubing Chilled Water Tank 3 Water Connection­ a R emove existing "Y" quick-connect To hot water fitting and discard. dispenser C onnect white 3/8" tube from White Tape the filter or water supply into the supplied "Y" quick-connect fitting until it stops. To chilled water tank "Inlet" From filter or water supply Insert 1/4" white tube from tank inlet into the 3/8" to 1/4" quick-connect fitting. To remove tube(s) or plug from quick-connector, depress the release ring and gently pull away. Identify copper HOT water tube, which is marked with white tape. Install that tube into the 3/8" to 1/4" quick-connect fitting. Note: Chilled water tank must be plugged directly into open wall outlet. 4 5