Intel D945PLNM D945PLNM Technical Product Specification - Page 28

Parallel Port, Diskette Drive Controller, Keyboard and Mouse Interface

Get Intel D945PLNM PDF manuals and user guides View all Intel D945PLNM manuals
Add to My Manuals
Save this manual to your list of manuals

Page 28 highlights

Intel Desktop Board D945PLNM Technical Product Specification 1.7.2 Parallel Port The 25-pin D-Sub parallel port connector is located on the back panel. Use the BIOS Setup program to set the parallel port mode. For information about The location of the parallel port connector Refer to Figure 12, page 47 1.7.3 Diskette Drive Controller The legacy I/O controller supports one diskette drive. Use the BIOS Setup program to configure the diskette drive interface. For information about The location of the diskette drive connector Refer to Figure 13, page 48 1.7.4 Keyboard and Mouse Interface PS/2 keyboard and mouse connectors are located on the back panel. NOTE The keyboard is supported in the bottom PS/2 connector and the mouse is supported in the top PS/2 connector. Power to the computer should be turned off before a keyboard or mouse is connected or disconnected. For information about The location of the keyboard and mouse connectors Refer to Figure 12, page 47 28

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
Intel Desktop Board D945PLNM Technical Product Specification
28
1.7.2
Parallel Port
The 25-pin D-Sub parallel port connector is located on the back panel.
Use the BIOS Setup
program to set the parallel port mode.
For information about
Refer to
The location of the parallel port connector
Figure 12, page 47
1.7.3
Diskette Drive Controller
The legacy I/O controller supports one diskette drive.
Use the BIOS Setup program to configure
the diskette drive interface.
For information about
Refer to
The location of the diskette drive connector
Figure 13, page 48
1.7.4
Keyboard and Mouse Interface
PS/2 keyboard and mouse connectors are located on the back panel.
±
NOTE
The keyboard is supported in the bottom PS/2 connector and the mouse is supported in the top PS/2
connector.
Power to the computer should be turned off before a keyboard or mouse is connected or
disconnected.
For information about
Refer to
The location of the keyboard and mouse connectors
Figure 12, page 47