Intel DE3815TYKHE User Guide - Page 4

Intel NUC Kit D54250WYK & D34010WYK User Guide Installing and Removing Memory Intel NUC Kits D54250WYK and D34010WYK have two 204-pin DDR3L SO-DIMM sockets. Memory requirements:  1.35V low voltage memory  1333 MHz or 1600 MHz SO-DIMMs  Non-ECC For a list of tested memory, go to the System Memory page on the Support site:  System Memory for Intel NUC Kit D54250WYK  System Memory for Intel NUC Kit D34010WYK Install SO-DIMMs If you plan to install just one SO-DIMM, install it in the upper memory socket. To install the SO-DIMMs, follow these steps: 1. Observe the precautions in "Before You Begin" on page 2. 2. Turn off all peripheral devices connected to the computer. Turn off the computer and disconnect the AC power cord. 3. Align the small notch at the bottom edge of the SO-DIMM with the key in the socket. 4. Insert the bottom edge of the SO-DIMM into the socket. 5. When the SO-DIMM is inserted, push down on the outer edge of the SO-DIMM until the retaining clips snap into place. Make sure the clips are firmly in place. Removing SO-DIMMs To remove a SO-DIMM, follow these steps: 1. Observe the precautions in "Before You Begin" on page 2. 2. Turn off all peripheral devices connected to the computer. Turn off the computer. 3. Remove the AC power cord from the computer. 4. Remove the computer's cover. 5. Gently spread the retaining clips at each end of the SO-DIMM socket. The SO-DIMM pops out of the socket. 4