Intermec PB31 Printer Handstrap Instructions

The handstrap (P/N 074789) provides a convenient way to carry your PB21, PB22,

PB31, PB32, PB42, PB50, or PB51 printer. With the handstrap attached, you can

also attach the shoulder strap (P/N 074788). The handstrap kit contains these

items:

•

Handstrap accessory

•

This instruction sheet

To attach the handstrap to the printer

1

Remove both ends of the handstrap from the strap adjusters that secure them to

the strap.

2

Insert one end of the handstrap through the handstrap clip on the printer.

Make sure the D-rings on the handstrap are facing away from the printer.

3

Pull the end of the handstrap through the handstrap clip and then insert the

end of the handstrap back through the strap adjuster and pull tight.

4

Repeat step 3 with the other end of the handstrap. You are now ready to use the

printer with the handstrap, or you can attach the shoulder strap to the D-rings

on the handstrap.

Printer Handstrap Instructions

Strap adjuster

Handstrap

clip