Invacare 4V08FFR Owners Manual - Page 37
Adjusting the Seat Width
View all Invacare 4V08FFR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
Invacare ® Veranda™ 3000/4000 6. Measure the distance the wheel lock is embedded into the tire as shown in Detail "A". Any wheel lock adjustment should embed the wheel lock shoe at least 1/8 inch into the tire when engaged. 7. Repeat the steps 1-6 until the wheel lock shoe embeds the tire 1/8 inch (3/16 inch for pneumatic tires) and holds the wheelchair. 8. Repeat STEPS 1-7 for the opposite wheel lock. 9. Engage both wheel locks and ensure the occupied wheelchair is held in place when pushed. 1/8 inch A B D C D E E 5.15 Adjusting the Seat Width When adjusting the seat width of the wheelchair, the back and seat upholstery MUST be changed. If applicable, the headrest pillow and headrest upholstery MUST be changed as well. 1. Remove the existing back and seat upholstery from the wheelchair. Refer to Replacing Back Upholstery and Replacing Seat Upholstery. 2. Remove the four button screws A and locknuts B that secure the two pivot links C to the wheelchair frame D and existing crossbraces E. 3. Remove the two button screws F, locknuts G and crossbrace saddle H that secures the bottom of the existing crossbrace to the wheelchair frame. Repeat for remaining crossbrace. 4. Remove the hex screw I, coved washers J, washers K and locknut L that secure the two existing crossbraces together. See Detail "B" Note the orientation of the coved washers, washers and locknut for assembling the new crossbraces. See Detail "B". 5. Assemble the two new crossbraces together with the existing hex screw, coved washers, washers and locknut. Securely tighten. Refer to Detail "B" for hardware orientation. 6. Determine the correct pivot link and mounting hole to use with the desired seat width. See chart below. SEAT WIDTH 16 INCH 18 INCH PIVOT LINK 16 inch 18 inch 20 INCH 20 inch 36 1567855-C